P41000AG High Voltage Transducer / Transmitter | Calibrated and Switchable
Description
The first Signal Conditioner with “Knick Curve” for Precise Measurement of DC Currents in Normal Operation and Measurement of Very High Currents in Overload Condition
- The P41000 AG fulfills two tasks in a single product:
- Continuous measurement of the regular supply current for timely detection of overcurrent events
- Measurement, until disconnection, of the large overcurrents occurring in the event of a fault
- This saves the need for an additional signal conditioner to measure overload currents and an additional measuring channel in a downstream protective device
- With the P41000 AG, currents are always measured in combination with a (Maconic) shunt resistor. The P41000 AG measures shunt voltages of between 30 and 120 mV
P41000 AG (adaptive gain) is designed to measure currents in electrical supply systems and large power-consuming devices.
In addition to precise current measurements in normal operation, it also measures high overload currents occurring in the event of a fault, e.g., due to short circuits, defects, storm damage, etc.
The current curves over time measured with the P41000 AG are analyzed with protective devices so as to interrupt the power supply early on in the event of a fault.
In order to enable key conclusions about the condition of the system, it is important to know the level and duration of the overload currents up to the time the power supply was interrupted. The P41000 AG makes this possible
Innovations at InnoTrans 2024 for rolling stock and DC traction power supply
Sept 2024
Interface Technology
We look forward to hearing from you!
Contact Us
| Function: | Current and overcurrent measurement via shunt resistor |
|---|---|
| Input: | 0 ... (±)30/330 mV up to 0 ... (±)120/1320 mV |
| Output: | 4 ... 16/24 mA |
| Isolation AC/DC: | up to 3,600 V |
| Test Voltage: | 10/15 kV AC |
| Power Supply: | 22 ... 230 V AC/DC |
| Cutoff Frequency: | Cutoff frequency 5 kHz, lower cutoff frequency on request |
| Ambient operating temperature: | –10 ... 70 °C |
| Dimensions (W x L x H): | 22.5 x 90 x 118 mm |
| Special features: | Adaptive gain for nominal current and overcurrent measuring, High accuracy in the nominal current range, sufficient accuracy for up to 11 times of nominal current |
| Standards: | UL 347 |
| Product Category: | High Voltage Transducer |
Downloads
Brochures
Certificates
Our service
Used in Process or Applications
Related Products
Relevant Blog Posts
Mar 2025
Process Analytics
SE605H Conductivity Sensor with CondCheck
Apr 2023
Process Analytics
Sturdy 2-Electrodes Conductivity Sensor SE625 with Coaxial Electrodes made of Titanium
Jun 2022
Process Analytics
Combined pH- and ORP-Sensor SE555X/*-AMSN
Nov 2021
Process Analytics
SE655X Digital and SE656X Digital - Digital Conductivity Sensors with Ex Certification
May 2021
Process Analytics